Knowledge Base

Installing your SSL Certificates in Juniper NetScreen

If you have not yet created a Certificate Signing Request (CSR) and ordered your certificate, see
SSL Certificate CSR Creation | Juniper NetScreen.

Juniper NetScreen SSL Certificate Installation

1. In the WebUI Options menu, select Objects and Certificates.
2. Load the Primary certificate:
   1. Select the circle to load a 'Cert'.
   2. Next to 'Show' select Local.
   3. 'Browse' for the Primary (your_domain_name.crt) certificate that you downloaded from your DigiCert Account, and hit Load.
3. Load the Intermediate Certificate:
   1. Select the circle to load a 'Cert'. 
   2. Next to 'Show' select CA. 
   3. 'Browse' for the Intermediate (DigiCertCA.crt) certificate that you downloaded from your DigiCert Account, and Load.
4. Load the Root Certificate:
   1. Select the circle to load a 'Cert'. 
   2. Next to 'Show' select CA. 
   3. 'Browse' for the Root (TrustedRoot.crt) certificate that you downloaded from your DigiCert Account, and Load.
5. Verify that your primary certificate loaded as a 'Local' certificate. The Intermediate and Root certificates should have been loaded as CA certificates. If the Primary certificate is loaded as a CA certificate, something is wrong. This usually happens because the domain is not properly set up on the device. To resolve this, you will need to configure the domain name (see CSR creation instructions), create a new CSR for a new certificate, and install the certificate again.
   
   The SSL Certificate installation on your NetScreen Device is now complete.